Angle type, Mate/unmate with socket, Max 20 pins connector, pitch=2.54mm

• Use to assemble PCB at right angles.
• 20 pins connected at 2.54mm pitch.
• Dielectic Strength....1000V AC, DC 1 min
• Finish....2.5µm as base plating, Ni / 0.1µm, Au on the surface
• Insulation Resistance....500M ohm or more
• Material....
  Pin part..Brass [C3604]
  Resin part..PBT resin RED [UL94V-0]
• Packing Specification....
  10 pieces / pack
  * It is not prescribing a pack quantity about the cut products.
• Rated Current....3A
• Rated Voltage....125V AC, DC
• Recommended Through-hole Diameter (phi mm)....0.8
• Resistance of Soldering Temperature....
  Temperature of solder-bath: 260 degree Celcius / Dip time: 10 sec
  Without the damage by heat.
• Solderability....
  Soak in flux 5 seconds, and then soak in 3 seconds in solder-bath of 230 degree Celcius.
  Solder wettability is required over 90% after soldering.
• Solvent-poof....
  2 minutes supersonic washing with IPA and alternatives for chlorofluorocarbon.
  No any discolorations, distortions and cracks.
• Temperature Range (Degrees Celcius)....-40 to +125
• Visual Examination....
  To be without defectives those may be obstruction to use.
  To be complied all dimensions with drawing.