Power source line, Recommended through-hole diameter, 0.6 to 0.8 phi mm
- Use it when patterns are thickly assembled on PCB, when it is impossible to take thickly power source, impossible power source patterns, etc.
- Dielectric Strength....1000V AC, DC
- Exterior Material....Epoxy resin blue (UL94V-0)
- Finish....Sn plating over Ni
- Material....Copper
- Rated Current....15A
- Recommended Male Pin Diameter (phi mm)....0.6 to 0.8
- Temperature Range (degrees Celsius)....-40 to +120
|
